|
Custom manufactured Strat® back plate.
White 1
Ply 0.120" Acrylic with a Rounded and Polished
Edge. Vintage style six oblong holes for strings to
pass through. Available in left or right handed
versions.
|
|
|
Our vintage style White
1 Ply 0.120" Acrylic Back Plate with the Rounded
and Polished Edge installed on a two-tone burst
Strat®.
|
|
Acrylic pickguards and
back plates are more fragile than the typical
vinyl ones most are familiar with. Always use
the utmost of care when installing components
into an Acrylic pickguard, never tighten any
fastener too tight and never tighten any
perimeter mounting screw any tighter than just
to the point where the screw barely snugs the
pickguard or back plate down to the surface of
the body. Never flex or put undue pressure
on any part of the Acrylic pickguard or back
plate or you will break it.
|
|
IMPORTANT ACRYLIC CLEANING NOTE:
When cleaning any Acrylic pickguard or back
plate ONLY USE the following approved
cleaners. Use of any other cleaning product
may damage the Acrylic.
- Novus #1, Plastic
Clean and Shine.
- Kleenmaster
Brillianize.
Both of these products
can be purchased from a company called
"Tap
Plastics". Here is a direct link to the
item page for the
Kleenmaster Brillianize and here is a
link for the
Novus #1.
|
|
Typical turn-around time from order placement to
shipment is up to 45 days. Holiday work-loads
sometimes may increase turn-around time, but keep in
mind, we don't waste any time in getting these prepared,
packed and shipped on their way to you.
Each back plate is custom manufactured for
each customer and does not qualify for
return, exchange or refund.
|
